Poulan-pro PR621 SNOW THROWER User Manual download pdf (Page 9)

Engaging the Auger Blades

To engage the auger blades, hold the control bar against

the handle (Figure 14).

Disengaging the Auger

Blades

To disengage the auger blades, release the control bar

(Figure 15).

The electrical cord can become damaged, causing

a shock or fire.

Thoroughly inspect the electrical cord before plug-

ging it into a power source. If the cord is damaged,

do not use it to start the snowthrower. Replace or

repair the damaged cord immediately. Contact an

Authorized Service Dealer for assistance.

IMPORTANT: Run the electric starter no more than 10

times at intervals of 5 seconds on, then 5 seconds off.

Running the electric starter extensively can overheat and

damage it. If the engine does not start after this series of

attempts, wait at least 40 minutes to allow the starter to

cool before attempting to start it again. If the engine does

not start after the second series of attempts, take the

snowthrower to an Authorized Service Dealer for service.

NOTE: If you pull the recoil handle and feel no resistance,

the starter may be frozen. Thaw out the starter before

attempting to start the snowthrower.

5. While the engine is running, move the choke lever

slowly to the right position.

6. Unplug the extension cord from the power source and

the snowthrower (Figure 12).

Unplug the power cord whenever you are not start-

ing the snowthrower.

Figure 14

1. Control bar

Figure 15

1. Control bar

1. Recoil start handle

Figure 13

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

No comments

Poulan-pro PR621 SNOW THROWER User Manual Page 9