Poulan-pro PRRT900 REAR TINE TILLER User Manual

Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the

10OPERATION• Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may con trib ute to excessive bo

11MAINTENANCEGENERAL RECOMMENDATIONSThe warranty on this tiller does not cover items that have been subjected to operator abuse or negligence. To re

12AIR CLEANER CARTRIDGECOVERAIR CLEANER SCREWMAINTENANCEOIL FILLERPLUGOIL LEVELOIL DRAINPLUGFig. 15Disconnect spark plug wire before performing any ma

13COOLING SYSTEM (See Fig. 18) Your engine is air cooled. For proper engine performance and long life keep your engine clean.• Clean air screen fre

14SERVICE AND ADJUSTMENTSCAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.TILLERTO ADJ

15SERVICE AND ADJUSTMENTSCABLE CLIPSCREWDRIVECONTROLCABLEEXTENSIONSPRINGENGINEPULLEYIDLERPULLEYTRANS MIS SION PULLEYLESS TEN SION5/8"MORETEN SIO

16SERVICE AND ADJUSTMENTSFig. 24• To maintain the superb tilling performance of this ma chine the tines should be checked for sharpness, wear, and b

17SERVICE AND ADJUSTMENTSENGINETO AD JUST CARBURETORThe carburetor has been preset at the factory and ad just ment should not be necessary. However,

18Immediately prepare your tiller for storage at the end of the season or if the unit will not be used for 30 days or more.WARNING: Never store the t

19 Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engi

2• Do not overload the machine capacity by attempting to till too deep at too fast a rate.• Never operate the machine at high speeds on slippery sur

20LIMITED WARRANTYThe Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in mate-rials an

3CONGRATULATIONS on your purchase of a new tiller. It has been designed, en gi neered and manu fac tured to give you the best pos sible de penda bil i

4TOOLS REQUIRED FOR ASSEMBLYA socket wrench set will make assembly easier. Standard wrench sizes are listed.(1) Utility knife(1) Tire pressure gauge(

5ASSEMBLY• Grasp handle assembly. Hold in “up” position. Be sure handle lock remains in gearcase notch. Slide handle assembly into position.Fig. 4

6ASSEMBLYSHIFTRODHAIRPINCLIPSHIFTLEVERINDICATORREMOVE TILLER FROM CRATE• Make sure shift lever indicator is in “N” position (See Fig. 6)• Tilt tille

7KNOW YOUR TILLERREAD THIS MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER.Compare the illustrations with your tiller to familiarize yourself wit

8TURNING• Release the tine control.• Move throttle control to “SLOW” position.• Place shift lever indicator in “F” (forward) position. Tines will

9• When you have completed your turn-around, release the tine control and lower handle. Place shift lever in till position and move throttle contro