Poulan-pro PP4000C User Manual download pdf (Page 4)

4

S Cut from your left to your right. Cutting on

the right side of the shield will throw debris

away from the operator.

S Use only in daylight or good artificial light.

S Use only for jobs explained in this manual.

TRANSPORTING AND STORA GE

S Stop the powerhead engine before carrying

unit.

S Keep muffler away from your body.

S Allow engine to cool and secure unit before

storing or transporting it in a vehicle.

S Empty the fuel tank before storing or trans-

porting the unit. Use up fuel left in the carbu-

retor by starting the engine and letting it run

until it stops.

S Store unit and fuel in an area where fuel va-

pors cannot reach sparks or open flames

from water heaters, electric motors or

switches, furnaces, etc.

S Store unit so the blade cannot accidentally

cause injury.

S Store unit indoors, out of reach of children.

If situations occur which are not covered in this

manual, use care and good judgment. If you

need assistance, call 1--800--554--6723.

SPECIAL NOTICE:Exposure to vibrations

through prolonged use of gasoline powered

hand tools could cause blood vessel or nerve

damage in the fingers, hands, and joints of

people prone to circulation disorders or abnor-

mal swellings. Prolonged use in cold weather

has been linked to blood vessel damage in

otherwise healthy people. If symptoms occur

such as numbness, pain, loss of strength,

change in skin color or texture, or loss of feel-

ing in the fingers, hands, or joints, discontinue

the use of this tool and seek medical attention.

An anti-vibration system does not guarantee

the avoidance of these problems. Users who

operate power tools on a continual and regular

basis must monitor closely their physical

condition and the condition of this tool.

SAVE THESE INSTRUCTIONS

ASSEMBLY

CARTON CONTENTS

Check carton contents for the following:

S Brushcutter attachment

S Handlebar

S Handlebar mounting bracket for 1″ shaft

S Handlebar mounting bracket for 7/8″ shaft

S Bracket cover (2)

S Shoulder strap

S Upper shoulder strap clamp

S Lower shoulder strap clamp (with spacer tabs)

S Handlebar bracket screws (4)

S Shoulder strap clamp screws (2)

S Attachment hanger

S Hex wrench

WARNING: If received assembled, re-

peat all steps to ensure your unit is properly as-

sembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE: If you need assistance or find that parts

are missing or damaged, call 1-800-554-6723.

TOOLS REQUIRED

S Hex wrench (provided)

INSTALLING BRUSHCUTTER AT -

TACHMENT

CAUTION:

When removing or installing at-

tachments, place the unit on a flat surface for

stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Attachment

Coupler

Knob

LOOSEN

TIGHTEN

2. Remove the shaft cap from the brushcut-

ter attachment (if present).

3. Position locking/release button of attach-

ment into guide recess of coupler.

4. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

5. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

WARNING: Make sure the locking/re-

lease button is locked in the primary hole and

the knob is securely tightened before operat-

ing the unit. Using the wrong hole could lead to

serious injury or damage to the unit.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments