Poulan-pro PP4218AVX User Manual download pdf (Page 7)

7

ASSEMBLY

Protective gloves (not provided) should be

worn during assembly.

ATTACH ING THE BAR & CHAIN (If

not already attached)

WARNING: If r ecei ved assemb led ,

repeat all steps to ensure your saw is properly

assembled and all fasteners are secure. Al-

ways wear gloves when handling the chain.

The chain is sharp and can cut you even when

it is not moving!

1. Move ON/STOP switch to the STOP

position.

2. Loosen and remove bar knob complete-

ly by lifting lever and turning counter-

cloc kwise.

LOOSEN

3. Remove clutch cover and plastic ship-

ping spacer (if present).

Clutch Cover

Bar

Knob

Location of

shipping

spacer

4. Slide guide bar on bar bolts until guide

bar stops against clutch drum sprocket.

Bar bolts

Guide bar

5. Carefully remove the chain from the pack-

age. Hold chain with the drive links as

shown.

CUTTERS MUST FACE IN

DIIRECTION OF ROTATION

Tip of

Bar

Cutters

Depth Gauge

Dri

v

e

L

inks

6. Place chain over and behind clutch re-

tainer, fitting the drive links in the clutch

drum sprocket.

7. Fit bottom of drive links between the

teeth in the sprocket in the nose of the

guide bar.

8. Fit chain drive links into bar groove.

9. Pull guide bar forward until chain is snug

in guide bar groove. Ensure all drive

links are in the bar groove.

10. Install clutch cover. Be sure adjusting

pin is in the adjusting pin hole in the

guide bar.

CAUTION: It is very important when instal-

ling the clutch cover that the adjusting pin

aligns into the adjusting pin hole in the bar . Fail-

ure to install the clutch cover correctly may re-

sult in permanent damage to your chain saw.

Back

view of

clutch

cover

Adjusting pin

11. Install bar knob and finger tighten only.

Once the chain is tensioned, you will

need to tighten bar knob.

CHAIN TENSION (In cluding units

with chain already installed)

WARNING: W ear protective gloves

when handling chain. The chain is sharp and

can cut you even when it is not moving.

NOTE: When adjusting chain tension,

make sure the bar knob is finger tight only.

Attempting to tension the chain when the bar

knob is tight can cause damage.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments