Poulan Pro PPB1000E Instruction Manual download pdf (Page 5)

STANDARDS:

This edger attachment is Listed by Underwriter’s Laboratories,Inc., in ac-

cordance with UL Standard 1602, “Gasoline--Engine--Powered, Rigid--Cutting--Member,

Edgers and Edger Trimmers,” only when used with the following models:

31cc Powerhead (with trimmer attachment) PP036............................

31cc Powerhead (with trimmer attachment) PP136............................

ASSEMBLY

W ARNING:

If received assembled,

repeatall steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE:

If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

TOOLS REQUIRED

Hex wrench (provided)

HANDLEBAR ASSEMBLY

DANGER:

RISK OF CUT. To avoid

serious injury, the barrier portion of the han-

dlebar must be installed as shown on the up-

pershaft ofthepowerheadtoprovide abarrier

betweenoperatorand the spinning blade. At-

tach shaftclamp abovearrowon safetywarn-

ing decal on the upper shaft (powerheadend

of unit). Ensure handlebar is positioned on

handlebar clamp between the arrows on the

handlebar decal.

NOTE:

The shaft clamp base has four

spacer tabs attached. These tabs are pro-

vided to adapt this attachment for use with

powerheads that have a 1

diameter upper

shaft(theshaftclamp will nottightendownse-

curely on the 1

diameter upper shaft without

using these spacer tabs). The tabs must be

broken off completely before use and placed

over the screw holes on the clamp base.

These tabs are not needed for powerheads

with a 7/8

upper shaft.

Spacer Tabs

HANDLEBAR CLAMP BASE

Spacer Tabs

positioned for use

on 1

diameter

upper shaft

1. Place the shaft clamp over the upper shaft

above the arrow on the safety decal.

2. Position the clamp base under the upper

shaft and align the shaft clamp and clamp

base screw holes (use spacer tabs be-

tween shaft clamp and clamp base if nec-

essary to secure clamp, i.e. for 1

diame-

ter upper shaft).

POWERHEAD

END

ATTACHMENT

END

Screws

Clamp

Base

Handlebar Clamp

between arrows on

handlebar decal

Clamp

Knob

Shaft

Clamp

Handlebar

Arrow on

Safety Decal

3. Insert the four screws into the screw

holes.

4. Secure shaft clamp by tightening screws

with the hex wrench.

5. Position the handlebar as shown, ensur-

ing the handlebar is positionedon the han-

dlebar clamp between the arrows on the

handlebar decal.

6. Retighten handlebar by turning clamp

knob clockwise until handlebar is secure

and stationary in clamp (clamp knob can-

not be overtightened).

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Poulan Pro PPB1000E Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Grass trimmers Poulan Pro PPB1000E