Poulan Pro PPB1000E Instruction Manual download pdf (Page 13)

13

Tip o

f

the line

does the cutting.

Ri

g

ht Wron

g

L

ine crowded into

work area.

S The line will easily remove grass and

weeds from around walls, fences, trees and

flower beds, but it also can cut the tender

bark of trees or shrubs and scar fences.

S For trimming or scalping, use less than full

throttle to increase line life and decrease

head wear, especially:

S During light duty cutting.

S Near objects around which the line can wrap

such as small posts, trees or fence wire.

S For mowing or sweeping, use full throttle for

a good clean job.

TRIMMING -- Hold the botto m of the trimmer

head about 3 inches (8 cm) above the ground

and at an angle. Allow only the tip of the line to

make contact. Do not force trimmer line into

work area.

Trimming

3 inches (8 cm)

above ground

SCALPING -- The scalping technique removes

unwanted vegetation down to the ground. Hold

the bottom of the trimmer head about 3 in. (8

cm) above the ground and at an angle. Allow the

tip of the line to strike the ground around trees,

posts, monuments, etc. This technique in-

creases line wear .

Scalping

MOWING -- Your trimmer is ideal for mowing

in places conventional lawn mowers cannot

reach. In the mowing position, keep the line

parallel to the ground. Avoid pressing the

head into the ground as this can scalp the

ground and damage the tool.

Mowing

SWEEPING -- The fanning action of the rotat-

ing line can be used to blow away loose debris

from an area. Keep the line parallel to and

above the area surface and swing the tool

from side to side.

Sweeping

MAINTENANCE

WARNING: Disconnect the spark

plug before performing maintenance except

for carburetor adjustments.

HELPFUL TIP

IMPORT ANT: Have all

repairs other than the rec-

ommended maintenance

described in the instruction

manual performed by an

authorized service dealer.

If any dealer other than an authorized

service dealer performs work on the

product, Poulan PRO may not pay for

repairs under warranty. It is your re-

sponsibility to maintain and perform

general maintenance.

CHECK FOR LOOSE

FASTENERS AND PARTS

S Spark Plug Boot

S Air Filter

S Housing Screws

S Assist Handle Screw

S Debris Shield

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for re-

placement of damaged or worn parts.

S ON/STOP Switch -- Ensure ON/STOP

switch functions properly by pushing and

releasing the switch. Make sure engine

stops. W ait 5 seconds before attempting to

restart unit to allow switch to reset. Restart

engine and continue.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments