Poulan-pro PP3816AV User Manual download pdf (Page 6)

6

Computed kickback angle (CKA) Table

BAR

P/N Length

CHAIN P/N

16″

MODEL

CKA without chain brake

PP3816AV

33_

PP4218AV / PP4218AVL

18″

952051211

952051338

952044942

952044926

33_

NOTE: Ifthissawistobeusedforcom-

mercial logging, a chain brake is required

and shall not be removed or otherwise dis-

abled to comply with Federal OSHA Regula-

tions for Commercial Logging.

SAFETY NOTICE: Exposure to vibrations

through prolonged use of gasoline powered

hand tools could cause blood vessel or nerve

damage in the fingers, hands, and joints of

people prone to circulation disorders or

abnormal swellings. Prolonged use in cold

weather has bee n linked to blo od vessel

damage in otherwise healthy people. If

symptoms occur such as numbness, pain,

loss of strength, change in skin color or texture,

or loss of feeling in the fingers, hands, or joints,

discontinue the use of this tool and seek

medical attention. An anti-vibration system

does not guarantee the avoidance of these

problems. Users who operate power tools on

a continual and regular basis must monitor

closely their physical condition and the

condition of this tool.

SPECIAL NOTICE: Y our saw is equipped

with a temperature limiting muffler and spark

arresting screen which meets the

requirem ents of California Codes 4442 and

4443. All U.S. forest land and the states of

California, Idaho, Maine, Minnesota, New

Jersey , Oregon, and Washington require by

law that many internal combustion engines to

be equipped with a spark arresting screen. If

you operate a chain saw in a state or locale

where such regulations exist, you are legally

responsible for maintaining the operating

condition of these parts. Failure to do so is a

violation of the law. Refer to the SERVICE

section for maintenance of the spark arresting

screen. Failure to follow all Safety Rules and

Precautions can result in serious injury . If

situations occur which are not covered in this

manual, use care and good judgement. If you

need assistance, contact your authorized

service dealer or call 1-800--554--6723.

STANDARDS: This saw is listed by Under-

writer’s Laboratories, Inc., in accordance with:

ANSI B175.1--2000 American National

Standards for Gasoline--Powered Chain

Saws -- Safety Requirements

CSA Z62.1--03 Chain Saws -- Occupational

Health and Safety

CSA Z62.3--96 Chain Saw Kickback Occu-

pational Health and Safety

ASSEMBLY

Protective gloves (not provided) should be

worn during assembly.

ATTACHING THE BAR & CHAIN (If not

already attached)

WARNING: If receive d assemb led ,

repeat all steps to ensure your saw is properly

assembled and all fasteners are secure. Al-

ways wear gloves when handling the chain.

The chain is sharp and can cut you even when

it is not moving!

1. Loosen and remove the bar nuts and the

clutch cover from the saw.

2. Remove the plastic shipping spacer (if

present).

Clutch cover

Bar nuts

Chain adjustment tool

(Bar Tool)

Location of

shipping

spacer

3. T urn adjusting screw on bar counterclock-

wise to move the tensioning rack as far as

it will go toward the front of the bar.

Tensioning Rack

Adjusting

Screw

4. Sli de guide bar on bar bolts until guide bar

stops against clutch drum sprocket.

Guide bar

Bar bolts

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Comments to this Manuals

No comments