Poulan-pro PP258TP User Manual download pdf (Page 8)

8

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE: If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the

empty fuel tank.

Finding fuel or oil residue on muffler is normal

due to carburetor adjustments and testing

done by the manufacturer.

TOOLS REQUIRED

S Hex wrench (provided)

INSTALL ING PRUNER ATTACH -

MENT

CAUTION:

When removing or installing at-

tachments, place the unit on a flat surface for

stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Coupler

Knob

LOOSEN

TIGHTEN

Shipping

protector

2. Remove shipping protector from coupler.

3. Remove the shaft cap from the pruner at-

tachment (if present).

4. Position locking/release button of attach-

ment into guide recess of coupler.

5. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

6. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

WARNING: M ake sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit. Al l attach ments a re des igned

to be used in the primary hole unless otherwise

stated in the applicable attachment instruction

manual. Using the wrong hole could lead to seri-

ous injury or damage to the unit.

Locking/Release

Button in Primary Hole

Secondary Hole

For optional attachments, see the AS-

SEMBL Y section of the applicable attach-

ment instruction manual.

SHOULDER STRAP ASSEMBLY

WARNING: Proper shoulder strap

adjustments must be made with the engine

completely stopped before using unit.

1. Try on shoulder strap and adjust for fit

and balance before starting the engine or

beginning a cutting operation.

2. Insert your right arm and head through

the shoulder strap and allow it to rest on

your left shoulder. Make sure the danger

sign is centered on your back and the

hook is to the right side of your waist.

NOTE: A one-half twist is built in the shoul-

der strap to allow the strap to rest flat on the

shoulder.

3. Adjust the strap, allowing the hook to be

about 3 -- 6 inches (8 -- 15 cm) below the

waist.

4. Fasten the strap hook to the clamp lo-

cated between the throttle handle and the

assist handle and lift the tool to the oper-

ating position.

NOTE: It may be necessary to relocate the

shoulder strap clamp on the shaft for proper

balancing of unit.

TO RELOCATE SHOULDER STRAP

CLAMP:

1. Loosen and remove both clamp screws.

2. Place the upper shoulder strap clamp

over the upper shaft.

3. Position the lower shoulder strap clamp

under the upper shaft and align the upper

and lower clamp screw holes.

Upper Shoulder

Strap Clamp

Screws

Lower Shoulder

Strap Clamp

POWERHEAD

END

ATTACHMENT

END

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Comments to this Manuals

No comments