Poulan Pro PP136E Instruction Manual download pdf (Page 12)

• DebrisShield- Discontinueuseofunitif

debrisshieldisdamaged.

INSPECTAND CLEAN UNIT AND DE-

CALS

• After each use. inspect complete unit for

loose or damaged parts. Clean the unit and

decals using a damp cloth with a mild deter-

gent.

• Wipe off unit with a clean dry cloth.

CLEAN AIR FILTER

A dirty air filter decreases engine perform-

ance and increases fuel consumption and

harmful emissions. Always clean after every

5 hours of operation.

1. Clean the cover and the area around itto

keep dirt from falling into the carburetor

chamber when the cover is removed.

2. Remove parts by pressing button to re-

lease air filter cover.

NOTE: To avoid creating a fire hazard or

producing harmful evaporative emissions, do

not clean filter in gasoline or other flammable

solvent.

3. Wash the filter in soap and water.

4. Allow filter to dry.

5. Replace parts.

Button

Air Filter

t!

Air Filter Cover

INSPECT MUFFLER AND SPARK

ARRESTING SCREEN

A_kWARNING: The muffler on this prod-

uct contains chemicals known to the State of

California to cause cancer.

As your unit is used, carbon deposits build up

on the muffler and spark arresting screen and

must be removed to avoid creating a fire haz-

ard or affecting engine performance.

For normal homeowner use, the muffler and

spark arresting screen will not require any

service. After 50 hours of use. we recom-

mend that your muffler be serviced or re-

placed by an authorized service dealer.

REPLACE SPARK PLUG

Replace the spark plug each year to ensure

the engine starts easier and runs better, in-

spect spark plug every 25 hours of usage.

Clean and/or replace as necessary. Set spark

plug gap at 0.025 inch (0.6 mm). Ignition tim-

ing is fixed and nonadjustable.

1. Twist, then pull off spark plug boot.

2. Remove spark plug from cylinder and

discard.

3. Replace with Champion RCJ-6Y spark

ptug and tighten securely with a 3/4 inch

(19 mm) socket wrench.

4. Reinstall the spark plug boot.

REPLACING THE LINE

1. Press the tabs on the side of the trimmer

head and remove cover and spool.

Cover

Tap Button

2. Remove any remaining line.

3. Clean dirt and debris from all parts. Re-

place spool if it is worn or damaged.

4. Replace with a pre-wound spool, or re-

place line using a 15 feet (4.5 meters)

length of 0.095 inch (2.4 mm) diameter

Poulan PRO brand line.

5. When installing new line on an existing

spool, hold the spool as shown in the il-

lustration below.

6. Bend the line at the midpoint and insert

the bend into the slot in the center rim of

the spool. Ensure line snaps into position

in the slot.

7. With your finger between the lines, wrap

the lines evenly and firmly around the

spool in a clockwise direction.

8. Position the lines in the guide slots.

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 50 51

Comments to this Manuals

No comments